The Primo CD Player Rev2.0 contains all the principal characteristics of Audio Analogue CD Player technology inside. Its smart look and its high level of construction quality permit the PrimoCDRev2.0 to embellish any environment where it is located!
The Cd Mechanism used is the CD-5010A specifically designed by Teac for high quality audio application. The CD-5010A has been developed on the basis of a CD ROM mechanism which decreases the rotation speed and improves the reading procedure. This has the particular advantage of cutting down the jitter output level. The Audio Analogue R&D staff has worked with Teac during the developing and testing of the Cd mechanism, especially with the mechanical and vibration tests.
The Digital to analogue conversion circuit is composed by a 96 KHz/24Bit very low recovered system clock (residual jitter less than 50ps!) Burr Brown receiver and by a 24 Bit/192KHz Enhanced Multilevel Delta Sigma architecture DAC. The conversion circuit is placed on a separated board to avoid any high frequency disturbance on the audio signal.
The output stage is a classic audio configuration in which Audio Analogue has put all its experience and knowledge choosing the best cut off filter frequency and the best components for the circuit. Both passive and active components have been chosen, including the operational amplifier as well. This selection was made not only on the basis of calculations, simulations, and measurements but also after careful listening tests.
The manager software implemented comes from a long and careful research finalized to take advantage of the CD Mechanism at its best for a perfect audio return and for the best CD player management.
The results achieved make the Primo Cd Player Rev2.0 a CD Player of the upper most quality characterized by a perfect return of the complete spectrum of musical colours and with a well defined, wide, real and believable listening stage.